Tap and die 32mm - Anybody have one near southend?
Discussion
Hey everyone,
I was just wondering if anybody local to Southend had a 32mm tap and die set? We need to re-thread the outer part of our SW20 driveshaft and seems senseless to buy one for this little job.
payment will be in beer tokens and copious amounts of gratitude!
Thanks very much,
Ant
I was just wondering if anybody local to Southend had a 32mm tap and die set? We need to re-thread the outer part of our SW20 driveshaft and seems senseless to buy one for this little job.
payment will be in beer tokens and copious amounts of gratitude!
Thanks very much,
Ant
Is 32mm the thread diameter, or the distance across the flats of the nut?
32 is a rather big thread for a driveshaft and the only place that would have one would be GAZ shocks, as I think that's the diameter of the shock tubes.
If is the nut size then the thread is more likely 20-22mm.
32 is a rather big thread for a driveshaft and the only place that would have one would be GAZ shocks, as I think that's the diameter of the shock tubes.
If is the nut size then the thread is more likely 20-22mm.
Gassing Station | Kent & Essex | Top of Page | What's New | My Stuff