Check out this fabrication
Discussion
Whether you like it or not this guys fabrication skills are fairly impressive http://www.geekologie.com/2008/08/diy_guy_building...
Not very impressed with that as it's very single curved but the wooden bodied super car directly below is mind blowing.
Direct link is www.joeharmondesign.com
On a local note, if it ever surfaces, the BMW M1 replica Frank Van Lingan rebuild in alloy from a EMW chassis is stunning.
Cheers
Mark
Direct link is www.joeharmondesign.com
On a local note, if it ever surfaces, the BMW M1 replica Frank Van Lingan rebuild in alloy from a EMW chassis is stunning.
Cheers
Mark
This is crafty too: http://www.calfeedesign.com/Bamboomtn.htm
Hi
Here are a few photos of a Kiwi showing the Poms how to build a car.
http://k80rum.co.uk/RacelineCar.aspx
Peter McEwan is the designer and builder - Ex Christchurch, now in Reading. He built the Duratech for my Caterham 7. When I collected it in '94 this car was just a bare spaceframe in the corner of the workshop. Good to see that he stuck with it.
Iain
Here are a few photos of a Kiwi showing the Poms how to build a car.
http://k80rum.co.uk/RacelineCar.aspx
Peter McEwan is the designer and builder - Ex Christchurch, now in Reading. He built the Duratech for my Caterham 7. When I collected it in '94 this car was just a bare spaceframe in the corner of the workshop. Good to see that he stuck with it.
Iain
Gassing Station | New Zealand | Top of Page | What's New | My Stuff