4 wheel alignment in EA? - petrol head friendly!
Discussion
Hi all,
Fed up with scrubbing the inside of my tyres due to the camber, I've spend a huge amount of money on some trick custom control arms for the AMG. Camber, toe and drop links for the rear, camber for the front.
I'm going to fit them in the next couple of weeks, which I am assuming is not going to be a 5 minute job, and I then need someone to align the car. I'll adjust them to approximately the length of the ones that come off, but no doubt the car will still be miles off.
Can someone please recommend a company that would be sympathetic to the parts I've fitted? Preferably within about 50 miles of Bungay.
Thanks!
Fed up with scrubbing the inside of my tyres due to the camber, I've spend a huge amount of money on some trick custom control arms for the AMG. Camber, toe and drop links for the rear, camber for the front.
I'm going to fit them in the next couple of weeks, which I am assuming is not going to be a 5 minute job, and I then need someone to align the car. I'll adjust them to approximately the length of the ones that come off, but no doubt the car will still be miles off.
Can someone please recommend a company that would be sympathetic to the parts I've fitted? Preferably within about 50 miles of Bungay.
Thanks!
I've tried (and failed) with a lot of garages that do wheel alignment around here.
Most of the better quality places (i.e. that I would trust to do any serious work on my car) don't have the equipment needed.
The best places I've found are STS Tyre Pros - they all (or at least the ones I've been to) have the Hunter Hawkeye system and from what I've seen you can't do it wrong even if you try.
Not sure what they'd do if you turned up with a bunch of non-standard parts wanting non-standard geometry though.
Most of the better quality places (i.e. that I would trust to do any serious work on my car) don't have the equipment needed.
The best places I've found are STS Tyre Pros - they all (or at least the ones I've been to) have the Hunter Hawkeye system and from what I've seen you can't do it wrong even if you try.
Not sure what they'd do if you turned up with a bunch of non-standard parts wanting non-standard geometry though.
Gassing Station | East Anglia | Top of Page | What's New | My Stuff