Hydraulic hose needed

[StescoG66]

Quick question folks. Hydraulic pipe from clutch slave to clutch master cylinder is weeping/leaking so need to get a new one made up. First thought was Pirtek, but was told their hoses not compatible with brake fluid. Asked a few clutch/gearbox specialist to no avail too.
It’s nothing fancy - flexible pipe with M12 x 14mm terminations each end, approx 1m long.any suggestions, preferably Glasgow area?

[generationx]

You should try and find a local motorsport specialist or race preparation shop. They will use braided brake/clutch lines extensively and should be able to either make something up from your sample or request it from their supplier. Typically you will need smooth-bore PTFE hose with a stainless steel braided outer. Then stainless steel fittings. Typical suppliers include well-known brands like Goodridge, Atec etc.

[StescoG66]

Thank you. Will see what I can find.

Don’t need anything fancy - it’s for a 1988 Alfa Sprint 1.7QV so hardly a high performance racer

[generationx]

If they can make up a line with bits on the shelf it shouldn't be too expensive, guessing £100-£200, it may seem like an over-the-top solution but it'll last as long as the car if done right. Best of luck!

[BillyWhizz888]

Mcgill motorsport at Kirkcaldy best bet.

Pietek and euro hydraulic all specialise in industrial side