Rover SD1 Timing Cover
Discussion
I need to replace the timing cover on my SD1 V8 engine as the oil pump housing is badly worn. I've tried all of the obvious suppliers and get the same story from them all, "You'll be lucky, haven't seen one of those for years!!"
Does anybody have a one lying around in the garage or know where I may be able to get one from, new or used??
Thanks,
Mike n Helen
Does anybody have a one lying around in the garage or know where I may be able to get one from, new or used??
Thanks,
Mike n Helen
is this what you are looking for ?
http://cgi.ebay.co.uk/Rover-V8-Cover-Morgan-Range-...
if not RPI may be able to help (details from the website above )
if that is no good, as wedg1e said may be cheaper to buy a full engine.
Phil
http://cgi.ebay.co.uk/Rover-V8-Cover-Morgan-Range-...
if not RPI may be able to help (details from the website above )
if that is no good, as wedg1e said may be cheaper to buy a full engine.
Phil
PRTVR said:
is this what you are looking for ?
http://cgi.ebay.co.uk/Rover-V8-Cover-Morgan-Range-...
if not RPI may be able to help (details from the website above )
if that is no good, as wedg1e said may be cheaper to buy a full engine.
Phil
If only life was this simple. That cover is for the later engine, to fit this on mine would mean a new water pump, dizzy, pulleys.....a big job.http://cgi.ebay.co.uk/Rover-V8-Cover-Morgan-Range-...
if not RPI may be able to help (details from the website above )
if that is no good, as wedg1e said may be cheaper to buy a full engine.
Phil
Think I'll try some local scrap yards, but I'm guessing there's not many SD1's around now. Wasn't sure if there were any Rover/V8 specialists in the area that I've over looked.
Mike n Helen
http://www.rimmerbros.co.uk/rimmer/sd1/eng-v8-indx
try these guys, they were VERY good when we were building my mates SD1 a while back.
HTH,
Stu
try these guys, they were VERY good when we were building my mates SD1 a while back.
HTH,
Stu
Gassing Station | North East | Top of Page | What's New | My Stuff