Well that's me off the road
Discussion
Drivers side rear wheel loose as a dangly thing. Tried to fix it last night, thanks to froggie for his help with this, but nothing doing. The bearing won't pull up or pull apart.
Richard, HHC, has organised for his low loader to come and take her away.
Looks like I'll be in the Mini for the Harewood Hillclimb.
Richard, HHC, has organised for his low loader to come and take her away.
Looks like I'll be in the Mini for the Harewood Hillclimb.
hope shes back soon bob.
looks like my clutch slave cylinder seals have failed,allong with the emisions for her test and to top that i lost £30 worth of juice as the replaced tank leaks,so thats gone for ally welding and the box is on its way out tomorow, the catalitic converter was glowing red and the heartproof sheild smoking during its mot,and i was hoping to finish the decats tomorow in time for a run to the british super bikes on sunday.my car is definatley female.stubbon and awcward too moove.
looks like my clutch slave cylinder seals have failed,allong with the emisions for her test and to top that i lost £30 worth of juice as the replaced tank leaks,so thats gone for ally welding and the box is on its way out tomorow, the catalitic converter was glowing red and the heartproof sheild smoking during its mot,and i was hoping to finish the decats tomorow in time for a run to the british super bikes on sunday.my car is definatley female.stubbon and awcward too moove.
Sorry to hear about your wheel!
Hope you get it back soon, I hate being TVRless whilst works being done
Mines due its MOT this week too which i'm not looking forward too!
Think I may have the same probs with emmisions as Froggie, i've started to get a slight rattle on the drivers side cat over the last few days. Do they test both exhausts or just one?? If I can test just the passie side it may pass.
I'ved got some de-cat pipes ready to go on as soon as it passes too!
>> Edited by mark.rowe on Friday 3rd June 01:08
Hope you get it back soon, I hate being TVRless whilst works being done
Mines due its MOT this week too which i'm not looking forward too!
Think I may have the same probs with emmisions as Froggie, i've started to get a slight rattle on the drivers side cat over the last few days. Do they test both exhausts or just one?? If I can test just the passie side it may pass.
I'ved got some de-cat pipes ready to go on as soon as it passes too!
>> Edited by mark.rowe on Friday 3rd June 01:08
????
Hi folks, twas the input shaft. A fault that had been on the car from new. I had thought that it would be something like this because the same fault had occurred a couple of years ago. The splines were under-cut so the hub was binding on it as the hub was being torqued up. It was reaching torque before the bearings were fully seated. Nice and tight when it's put together but over time the outer race was working its way further onto the input shaft causing the hub and shaft to slogger in the hub carrier.
New input shaft fitted, all's well.
Next event for me will be the NE Slalom day then Shaftos.
New input shaft fitted, all's well.
Next event for me will be the NE Slalom day then Shaftos.
Gassing Station | North East | Top of Page | What's New | My Stuff