Welder fabricator needed in birtley/washington area.

[andy-w]

Hi All,

Does anyone know of a good/cheap welding fabrication shop in the Birtley/Washington area...?

I am removing the air flow meter in my TVR and need a peice of tube 75mm dia 300mm long with a boss that has a 3/8" ntp thread welded in the middle to take an air temp sender.

I just need this last part and the chim is back on the road with megasquirt and edis electronic ignition...!!!

Even just someone who could make the boss would be a help...!

[Red16]

What material is your tube? Aluminium, mild steel, stainless steel?

If mild steel this adaptor with the BSP male threads cut off would do exactly what you need.

http://www.ebay.co.uk/itm/HYDRAULIC-FITTING-3-8-BS...

[poj]

Cummimgs engineering,station Lane Birtley(just at the Birtley brickworks entrance) should be able to do that for you,failing that there is another company in Portobello called rod and custom

[andy-w]

Was open on material choice but i think i might have cracked it.
I was thinking of using a BSP socket and cutting that in half, i know the threads are different by .5mm but it will go on a few turns which should be enough as it is not taking any pressure.

I will go and have a look at rod and custom in portabello though as i have seen the signs and want to go and have a nosey...!