Discussion
you can see in this one what the heater is fixed to on the dash not
very strong the old one had a bit on the bottom of it that sat on the
floor but the new one didn't have this so i packed it up with carpet to
support a bit more and you have to get it as forward possible or the temp
gauge hits the pipe on the front of the heater and you have to take it
all out again (yes i did have to ) lol
very strong the old one had a bit on the bottom of it that sat on the
floor but the new one didn't have this so i packed it up with carpet to
support a bit more and you have to get it as forward possible or the temp
gauge hits the pipe on the front of the heater and you have to take it
all out again (yes i did have to ) lol
Edited by Barry S1 on Monday 14th February 20:37
Hi Mikel
i paid £45 plus P&P from Norman (gerald-tvr) what is wrong with yours
the motor is ok on my old one the flap on the top had fallen in it and
was hitting the fan and has broken some of the fins on it if you wont it
i can send the hole thing to you just pay me the post £10 ish i think
you my be able to make a good one out of the two if you can get the motor
out of it
i paid £45 plus P&P from Norman (gerald-tvr) what is wrong with yours
the motor is ok on my old one the flap on the top had fallen in it and
was hitting the fan and has broken some of the fins on it if you wont it
i can send the hole thing to you just pay me the post £10 ish i think
you my be able to make a good one out of the two if you can get the motor
out of it
Gassing Station | S Series | Top of Page | What's New | My Stuff