Most perculiar tick-over??
Most perculiar tick-over??
Author
Discussion

Big Ian

Original Poster:

335 posts

259 months

Friday 4th November 2005
quotequote all
My s has just developed a most perculiar tick-over.
It started by deciding to ticv-over at 1500rpm rather than the usual 850.
Then....
two seconds at 1100, two seconds at 1500, two seconds at 1000, two seconds at 1500, etc etc etc.

Discuss!

Rower

1,381 posts

295 months

Friday 4th November 2005
quotequote all
Big Ian said:
My s has just developed a most perculiar tick-over.
It started by deciding to ticv-over at 1500rpm rather than the usual 850.
Then....
two seconds at 1100, two seconds at 1500, two seconds at 1000, two seconds at 1500, etc etc etc.

Discuss!




T.P

tvrgit

8,489 posts

281 months

Friday 4th November 2005
quotequote all
Rower said:
Big Ian said:
My s has just developed a most perculiar tick-over.
It started by deciding to ticv-over at 1500rpm rather than the usual 850.
Then....
two seconds at 1100, two seconds at 1500, two seconds at 1000, two seconds at 1500, etc etc etc.

Discuss!




T.P

Possibly throttle pot, yes, but not necessarily. Could be idle speed valve, air flow meters (unless it an S3C) Lambda sensor (if it is an S3C!) wiring or connector fault, inlet manifold or throttle butterfly leak, etc etc.

You're probably right, though...

doddze

1,302 posts

268 months

Saturday 5th November 2005
quotequote all
TP......... been there got the t shirt!!!!!! When mine did it it settled at 2500 rpm as tick over.... which is a bit loud!!

get a new one for £35 and be sorted IMHO

bugsy

1,371 posts

265 months

Saturday 5th November 2005
quotequote all
I was told to disconnect the TP to see if that improved things, if so replace.

johns3

93 posts

259 months

Sunday 6th November 2005
quotequote all
Ive got the same problem as well as some jerky movement when im travelling at a constant speed. Im suspecting throttle pot but could be many things. In what order should I be replacing things? im thinking replace throttle pot first as this is a common fault.

doddze

1,302 posts

268 months

Sunday 6th November 2005
quotequote all
bugsy said:
I was told to disconnect the TP to see if that improved things, if so replace.


disconnect the TP at the connector block just below it. Make sure wires are out of the way. If car runs smooth highly likely to be the TP.... it is basically bypassing the TP and putting the car into a safe mode. If the bad running is still there then it is likely to be something else..

ceejay73

489 posts

257 months

Sunday 6th November 2005
quotequote all
I had the same problem as Johns3. Fault went away when TP was disconnected but after replacing pot with new the fault immediately re-appeared! Traced it to the multi-plug situated under the ignition coil and just above cylinder 2 (the TP wiring goes through this connector), it wasnt made properly, quick squirt with the WD40 and plug back together and fault was gone . Maybe worth checking if disconnecting pot gets rid of problem.
Carl.

>> Edited by ceejay73 on Sunday 6th November 19:57

Big Ian

Original Poster:

335 posts

259 months

Monday 7th November 2005
quotequote all
As always, quick and to the point.
It did start on Thursday, whilst driving through the wettest conditions yet.

Cheers