Help needed with door window fasteners
Discussion
Dear all,
I have had a problem that the rubber at the back of the door window on topp of the door keeps being pushed off when the window goes up on my S3.
I recently saw that the screws, that I supose hold the window frame inside the door, is gone.
Can somebody here please check what they are. I think the upper one is a wood screw into the fiberglass but the lower may be a threaded screw.
Kind regards
//Rob
I have had a problem that the rubber at the back of the door window on topp of the door keeps being pushed off when the window goes up on my S3.
I recently saw that the screws, that I supose hold the window frame inside the door, is gone.
Can somebody here please check what they are. I think the upper one is a wood screw into the fiberglass but the lower may be a threaded screw.
Kind regards
//Rob
Here it is, but as you can see it is not a countersunk screw, probably because I don't have many of those in stainless.
Suspect it started off at 10mm long but point has been ground of so now its only about 8mm and I'd guess an 8 gauge?
Might do the job?
https://www.ebay.co.uk/itm/182350430496?var=484898...
Suspect it started off at 10mm long but point has been ground of so now its only about 8mm and I'd guess an 8 gauge?
Might do the job?
https://www.ebay.co.uk/itm/182350430496?var=484898...
Edited by phillpot on Thursday 12th August 18:23
have been out to check and post a helpful photo....and have added another item to my list be sorted.
drivers side lower missing, but has a countersunk hole, upper is a raised countersunk posi head.
nearside lower snapped off/missing, has countersunk hole, upper is a raised countersunk posi head.
Bil
drivers side lower missing, but has a countersunk hole, upper is a raised countersunk posi head.
nearside lower snapped off/missing, has countersunk hole, upper is a raised countersunk posi head.
Bil
Gassing Station | S Series | Top of Page | What's New | My Stuff