Discussion
I did exactly that- fabricated replacement SS straps for a Reliant Scimitar a few years back.
its very simple; measure total length of existing straps. Get some cut same length (& width& gauge) from Stainless strip. either swap rubber from originals or obtain replacement if you can and bond onto new set
copy locations of holes and bends from originals onto your new pair. drill holes, then bend in same locations and orientation using a vice or similar.
its very simple; measure total length of existing straps. Get some cut same length (& width& gauge) from Stainless strip. either swap rubber from originals or obtain replacement if you can and bond onto new set
copy locations of holes and bends from originals onto your new pair. drill holes, then bend in same locations and orientation using a vice or similar.
Gassing Station | S Series | Top of Page | What's New | My Stuff