Washer Wiper Intermittent and Mod Cons
Discussion
i've had my eye on this for a while and been thinking of treating myself. Mostly for the MG (dash panel switch so even more inconvenient), but I think it would work on the TVR too
http://www.smart-screen.co.uk/contents/en-uk/d39.h...
http://www.smart-screen.co.uk/contents/en-uk/d39.h...
I am getting the feeling that
1. there is already a pull-down single wipe facility on the stalk
2. I have bought a different stalk with the stay down detent.
3. If the wiring connects up, I should just be able to fit a cycle timer on the pull-down circuit that emulates pulling the stalk down every 10 seconds or so? with a 0.5 second on, 10 second off cycle…or similar
When I have a bit of free time, I will have a play :-)
What can go wrong?
1. there is already a pull-down single wipe facility on the stalk
2. I have bought a different stalk with the stay down detent.
3. If the wiring connects up, I should just be able to fit a cycle timer on the pull-down circuit that emulates pulling the stalk down every 10 seconds or so? with a 0.5 second on, 10 second off cycle…or similar
When I have a bit of free time, I will have a play :-)
What can go wrong?
Top Gear TVR said:
I am getting the feeling that
1. there is already a pull-down single wipe facility on the stalk
2. I have bought a different stalk with the stay down detent.
3. If the wiring connects up, I should just be able to fit a cycle timer on the pull-down circuit that emulates pulling the stalk down every 10 seconds or so? with a 0.5 second on, 10 second off cycle…or similar
When I have a bit of free time, I will have a play :-)
What can go wrong?
I had the same issue several years ago. The light switch part of the stalk failed on my S2 and I replaced it with a new stalk. However, the new stalk didn't have the pull down single wipe facility on the windscreen wipers as you mention. I couldn't find a direct replacement.1. there is already a pull-down single wipe facility on the stalk
2. I have bought a different stalk with the stay down detent.
3. If the wiring connects up, I should just be able to fit a cycle timer on the pull-down circuit that emulates pulling the stalk down every 10 seconds or so? with a 0.5 second on, 10 second off cycle…or similar
When I have a bit of free time, I will have a play :-)
What can go wrong?
In the end I bought an intermittent wipe relay from ford a bit like this one (I think mine was from a ford transit):
Click here
and wired it in using some info I found on the web - I can PM you a copy of the wiring diagram. It wasn't very difficult but it may involve you finding additional terminals for the missing ones on the multi-connector in the loom that plugs onto the stalk.
You may also need to heat the stalks up and bend them away from the dashboard so they don't foul, some more info here:
Click here
Hope this helps / makes some sort of sense......
Gassing Station | S Series | Top of Page | What's New | My Stuff





I must admit it was only fairly recently that I saw people using Camelback bags hung up inside wheel arches.
