Rear driver side wing needed

[Paceracing]

I don't know if anyone here can help, I am trying to get hold of a REAR DRIVER side wing for an S series, (preferably S2 although I think they are all the same anyway).
Ideally, the section should be intact and go from just in front of the rear wheel arch, near where it meets the sill, to a back panel at least half the rear width of the car, (boot lid not required).
(I am looking at a damaged S to build as a race car)

If anyone can help, even second hand parts, I would be very grateful.

Jas.

>>> Edited by Paceracing on Monday 13th May 23:46

[mhibbins]

I guess these are pretty rare so can you not make a pattern and make your own from a good wing then you can get it exactly the shape you need. Shouldn't be too difficult.

[GreenV8S]

quote:I don't know if anyone here can help, I am trying to get hold of a REAR DRIVER side wing for an S series, (preferably S2 although I think they are all the same anyway).
Ideally, the section should be intact and go from just in front of the rear wheel arch, near where it meets the sill, to a back panel at least half the rear width of the car, (boot lid not required).
(I am looking at a damaged S to build as a race car)

If anyone can help, I would be very grateful.

Jas.

Glad it isn't for *your* S, I was starting to worry! Tower View have a large stock of moulds for the recent models and made a whole new rear end for mine when I was "Escorted" across a zebra crossing a couple of years ago. They're also 'motorsport friendly' so if you explain what it's for you may find they can help out.

Cheers,
Peter Humphries (and a green V8S)

[pistolar]

i have a mould for the rear corner can make you a new section e mail [e-mail] if interested