Boot cover options
Discussion
I'd imagine someone could fabricate one in aluminium or fibreglass for you. The design around the rollbar could be interesting from a weather-tight but still accessible point of view. One thing to consider is that the flexible vinyl allows minor overfilling of the boot - very useful on Euro tours
made my own http://picasaweb.google.com/kevrusselli/BootCover#... based on the arch cover, needed the middle section to be removable as opposed to the side bits on the arch cover. this allowed me to fit the filler in the right hand side cover. the front slides under an ali channel rivetted to the rear bulk head. the middle section is zues fitted to brackets on the roll over bar mounting. all made from 1.5mm ali.
Martin, it is probably not easily seen in the photographs but the cc/ arch cover,the blue one, has a turned over safety edge, because i used a slightly thicker material i just finished with a smooth sanded edge. the finishing touch though was to turn down the last 10mm of the edge slightly, the cc one is the same in this respect. i acheived this by cutting a thickish piece of board MDF to the same shape as the cover but 10mm smaller around the edge this was then tapped down with a mallet on another board with some thin hardboard shaped just smaller than the cover. difficult to explain without pics. will try to get a sketh up on picasa to show the technique.
russelli said:
made my own http://picasaweb.google.com/kevrusselli/BootCover#... based on the arch cover, needed the middle section to be removable as opposed to the side bits on the arch cover. this allowed me to fit the filler in the right hand side cover. the front slides under an ali channel rivetted to the rear bulk head. the middle section is zues fitted to brackets on the roll over bar mounting. all made from 1.5mm ali.
I am liking that.Gassing Station | Caterham | Top of Page | What's New | My Stuff