X Flow Forged Pistons

[Captain Spoons]

Any advice on where to source a set of Forged pistons for the Xflow Supersprint and rough costings
Anything else i would need at the same time??

Cheers in advance

[Eugene7]

Sorry, can't help directly, but I did have forged pistons in my old X-Flow. They are in DieterS47's Series 4 now...

I'd suggest chatting to Chris at The 7 Workshop - www.7workshop.com

He's great on X-Flows.

[pikeyboy]

Burton power might be a good place to try, they have loads of performance ford enigne parts in their online catalogue.

[BDA]

As Pikey said, Burtons sell Accrilites which as good as you will get for your money. Cannot remember the cost but prob about £600 a set. if yours is a standard supersport it SHOULD be 83.25mm bore. Accrilites sell a 83.5mm piston which is all should need all being well if it is only a general rebuild. You shouldn't really go bigger than this if you have a 711M block either.

Cheers
Chris

[elan_fan]

You could fit Lotus twincam pistons with the crown machined off slightly. Make for a much lighter piston which is good for your rev limit. Retail around the 400GBP mark. I have used asso pistons like this in the past.