K series R500 Geo and suspension factory settings
Discussion
Hi Guys needing a bit of help asap as getting corner weights and suspension set up tonight for this weekend's racing. I need the settings as the r500 would be for when it came out of the factory. Been having a scan about but not having much luck. Any help would be much appreciated. Many Thanks Aaron
supamondo said:
Hi Guys needing a bit of help asap as getting corner weights and suspension set up tonight for this weekend's racing. I need the settings as the r500 would be for when it came out of the factory. Been having a scan about but not having much luck. Any help would be much appreciated. Many Thanks Aaron
Without being faceacious (sp?) I think the last thing you want a re the *factory* settings for the geo. Most factory setups seem to be done using cotton wool to measure things with Give Fauldsport or Team Parker Racing a call for some clarity.
120mm front ride height on a wet sump car would be dangerously low if used on the road & probably fall foul of race regs as well.
That geo was with Eibach race springs all round 250lbs & the stiffest ARB.
I do have the proper castor somewhere, but washer counting is easier to remember!
That geo was with Eibach race springs all round 250lbs & the stiffest ARB.
I do have the proper castor somewhere, but washer counting is easier to remember!
Edited by croftsj on Thursday 28th May 19:01
Gassing Station | Caterham | Top of Page | What's New | My Stuff