Help with Speedo Calibration R400 Duratec
Discussion
The Speedo on my R400 Duratec has put itself into the calibration mode and I think I've changed the settings as it now reads about 20 - 30 miles below actual speed!!
It's one of the new types that are calibrated by pressing the milage reset switch when ignition is on...
Does anybody now what the correct calibration number should be for an R400 Duratec running on 15inch Avon Cr500's???
I'm sure it would be the same on anybody elses R400 Duratec running same tyres. The number is displayed if you hold the milage reset button for 3 seconds with the igntion on. If you then leave it it will cycle through with out making any alterations...
Any help in this matter will be greatly appreaciated..
It's one of the new types that are calibrated by pressing the milage reset switch when ignition is on...
Does anybody now what the correct calibration number should be for an R400 Duratec running on 15inch Avon Cr500's???
I'm sure it would be the same on anybody elses R400 Duratec running same tyres. The number is displayed if you hold the milage reset button for 3 seconds with the igntion on. If you then leave it it will cycle through with out making any alterations...
Any help in this matter will be greatly appreaciated..
Hi
try here http://www.tyretraders.com/Tyrecalculator/ type in wheel size and it works out rolling radius for you
Also do you have a stack dash ?
try here http://www.tyretraders.com/Tyrecalculator/ type in wheel size and it works out rolling radius for you
Also do you have a stack dash ?
Edited by markiebabes on Thursday 26th February 23:17
Gassing Station | Caterham | Top of Page | What's New | My Stuff