2012 Roadsport - Wheel Bearing Service
Discussion
I am trying to remove, clean and repack the front wheel bearings.
I have removed the brake pads and caliper, and cable tied the later to the suspension, out the way of the disc.
I have removed the split pin and castellated nut from the stub axle. I have removed the spacer washer and was hoping the disk and hub would now pull off the axels, but it won’t budge.
I have sprayed some WD40 on it and left it to soak.
Should I use a hub puller, or are there better options / approaches?
I have removed the brake pads and caliper, and cable tied the later to the suspension, out the way of the disc.
I have removed the split pin and castellated nut from the stub axle. I have removed the spacer washer and was hoping the disk and hub would now pull off the axels, but it won’t budge.
I have sprayed some WD40 on it and left it to soak.
Should I use a hub puller, or are there better options / approaches?
Edited by gf07050 on Sunday 9th January 00:20
Edited by gf07050 on Sunday 9th January 00:20
They should pull straight off without too much effort. If they don't then the inner races are tight for some reason (possibly because they have been rotating on the stub axle) and may need a puller to free them, or you could try putting the wheel back on to give you something larger to pull with.
Gassing Station | Caterham | Top of Page | What's New | My Stuff