Toe / Camber / Caster
Discussion
I would say that the settings on Blatchat are a little conservative
Although it's track and driver dependent I would start with...
Front:
camber 2.5 - 3.0
toe 5' toe out
Castor 2 or 3 washers between the front of the chassis and the lower wishbone, although check that it's the same on both sides with a gauge if you can
Rear:
Camber 1.5
Toe 5' in - 0
Ride heights:
These cars are very rake sensitive. Set this at 12-15 mm (conservative) Front ride height 115-120mm (measure fron the floor to the bottom of the chassis rail just behind the rear lower wishbone mount)
Tyre pressures:
Set them hot if you can, and aim for ~21 all round
You don't say whether or what rear ARB you have. I would stick a red front one on (no rear) and go from there
Although it's track and driver dependent I would start with...
Front:
camber 2.5 - 3.0
toe 5' toe out
Castor 2 or 3 washers between the front of the chassis and the lower wishbone, although check that it's the same on both sides with a gauge if you can
Rear:
Camber 1.5
Toe 5' in - 0
Ride heights:
These cars are very rake sensitive. Set this at 12-15 mm (conservative) Front ride height 115-120mm (measure fron the floor to the bottom of the chassis rail just behind the rear lower wishbone mount)
Tyre pressures:
Set them hot if you can, and aim for ~21 all round
You don't say whether or what rear ARB you have. I would stick a red front one on (no rear) and go from there
Gassing Station | Caterham | Top of Page | What's New | My Stuff