Gixer - correction gears.
Discussion
Propshaft out the back of the gear box
At the rear drivers side of box there is a small hex bolt that hols a curved metal bracket against the gearbox housing - remove this
The drive assay will now pull out. Swap over the conical gear
The other gear needs to be slid out of the box towards the rear of the car. It sits over a spring clip that sit in a notch in the gear. Its a pig to get to just be patient
At the rear drivers side of box there is a small hex bolt that hols a curved metal bracket against the gearbox housing - remove this
The drive assay will now pull out. Swap over the conical gear
The other gear needs to be slid out of the box towards the rear of the car. It sits over a spring clip that sit in a notch in the gear. Its a pig to get to just be patient
Cheers Gix, also found this page on MH's site. Mind you they fit well in the glove box
http://www.zr1specialist.com/HAT%20Web/products/Sp...
http://www.zr1specialist.com/HAT%20Web/products/Sp...
Gassing Station | Corvettes | Top of Page | What's New | My Stuff