Nissan NV250 1.5 dCi Acenta Panel Van 5dr Diesel Manual L2 Euro 6 (s/s) (95 ps)

Meals on wheels conversion Operating / Working the Oven Regn Electric (Electric use only 120 Degrees setting) Regn Diesel (95 Degrees setting) Road Diesel (75 Degrees setting) - Turn on the oven prior to loading on all operations. - Oven on Diesel to be turned on to the Regenerating position (Regen Diesel). - Put food into the oven when satisfied with the pre-heated temperature. - Load the food into the oven to regenerate to your preferred core temperature. - When the core temperature has been achieved, switch the oven to its holding temperature position (Road diesel). Switching operation from Diesel Regen to Road Diesel - Important: Switching the oven from regeneration to holding, you must have both switches (Regen Diesel and Road Diesel) in the 'on' position. - When both switches are in the 'on' position, the displays on both controls will read unusual figures. When the figures have settled, turn off the Regenerating switch and leave the Road Diesel on. The controller on the Road Diesel will change back to the oven temperature. - Switching to Road Diesel will allow the oven to cycle at 75 degrees centigrade +/-2 degrees. - If at any time you wish to return the oven to Regenerating temperatures (increase food temperature), repeat the above procedure and turn off the Road Diesel holding temperature switch. If the above procedures are not followed, the oven will automatically go into a safety mode and will not heat for approximately 15-20 minutes. When you have finished with your last delivery, turn off whichever switch you have on. Electric operation - Plug the power lead into the side of the vehicle, lifting up the white flap. - Switch on Regen Electric. You will see at this stage two controllers will display the oven temperature. - The oven temperatures are preset to 120 degrees centigrade, and when the air temperature has been achieved, the ovens will cycle on a 2-degree differential. - When changing over from electric to diesel, you must pull out the standby lead and turn off the electric switch before turning on any of the diesel switches. - Before driving away, please ensure you have disconnected the 240-volt lead from the vehicle. Important: Monitor the temperatures on electric so you do not overheat the food. On all operations, when finished, turn off all switches.

Features:

White,Cloth - Tanega,12V Socket - Front,15in Steel Wheels - Nissan Design,2 DIN Radio,ABS with EBD,AUX Port,Airbag - Driver,Audio Switch on Steering Wheel,Bluetooth,Central Storage Tray Between Front Seats,Central Storage and Armrest,Centre Console with Bottle Holder and Plastic Armrest,Closed Glovebox,DAB Digital Radio,Dark Grey Side Protection Mouldings,Driver Belt Warning and Buzzer,Driver Seat Slide - Reclining and Height Adjustment,Driver and Passenger Compartment Door Bins,Driver and Passenger Sun Visor with Pocket,Electric Folding and Heated Door Mirrors,French Doors,Front Electric Windows,Front Fog Lights,Front Headrests,Front Manual A-C,Full Steel Bulkhead,Grained Mirror and Bumpers,Height Adjustable Front Seatbelts,Hill Start Assist,Immobiliser,LED Daytime Running Lights,Left Side Sliding Door,Load Area Lighting,Low Fuel Level Warning Light,On Board Computer,One Touch Front Electric Windows,Overhead Parcel Shelf,Power Assisted Steering,Radio - CD Player,Rear Parking Sensor,Remote Central Locking with 2 Button Key,Rev Counter,Right Side Sliding Door,Roof Bar Fixings,Side Sheet Metal Panels,Spare Wheel,Steering Wheel Audio and Hands Free Controls,Superlocking,Thatcham Category 1 Alarm,Tie-Down Rings in Load Compartment,Trip Computer,USB Socket,Unglazed Rear Doors - 180 Degree Asymmetric,VDC - Vehicle Dynamic Control